ISO INTERNATIONAL STANDARD 11296-3 Second edition 2018-08 Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks Part 3: Lining with close-fit pipes Systemes de canalisations en plastique pour la renovation des réseaux debranchements et de collecteurs d'assainissement enterres sans pression Partie 3:Tubage par tuyau continu sans espace annulaire Reference number IS0 11296-3:2018(E) ISO @IS0 2018 IS011296-3:2018(E) COPYRIGHTPROTECTEDDOCUMENT IS02018 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone:+4122749 0111 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2018 - All rights reserved IS011296-3:2018(E) Contents Page Foreword ..V Introduction. ..vi 1 Scope. 2 Normative references .2 3 Terms and definitions .2 3.1 General 2 3.2 Techniques 3.3 Characteristics .2 .2 3.4 Materials 3.5 Product stages 2 3.6 Service conditions. .2 3.7 Joints. .3 4 Symbols andabbreviatedterms .3 5 Pipes at the "M" stage .3 .3 5.1 Materials. 5.1.1 General. 3 5.1.2 DistinctionbetweenPVC-Utypes .3 5.1.3 Virgin material .3 5.1.4 Reprocessable material and recyclable material 3 5.2 General characteristics. .4 5.2.1 Appearance. 4 5.2.2 Colour. .4 5.3 Material characteristics. 4 5.4 Geometric characteristics ..5 5.5 Mechanical characteristics. .5 5.6 Physical characteristics .5 5.7 Jointing. .5 5.8 Marking .6 6 Fittings at the"M" stage .6 7 Ancillary components .6 8 Fitness for purpose oftheinstalled lining system at the"I" stage 8.1 Materials. .6 8.2 General characteristics 8.3 Material characteristics .6 8.4 Geometric characteristics. .6 8.5 Mechanical characteristics. .8 8.6 Physical characteristics 9 8.7 Additional characteristics. .9 8.8 Sampling .9 9 Installation practice .9 9.1 Preparatory work .9 9.2 Storage, handling and transport of pipes and fittings .9 9.3 Equipment. 9.3.1 Butt fusion equipment and debeading equipment. 9 9.3.2 Reduction equipment. .10 9.3.3 Pipe skids/rollers.. .10 9.3.4 Winching and rod-pulling equipment ..10 9.3.5 Pipe entry guides. ..10 9.3.6 Reforming equipment .10 9.3.7 Electrofusionequipment ..10 9.3.8 Inspectionequipment .11 @ IS0 2018 - All rights reserved ili