ISO INTERNATIONAL STANDARD 5610-12 Secondedition 2014-09-01 Tool holders with rectangular shank for indexable inserts - Part 12: Style S Porte-plaquette a queue rectangulaire pour plaquettes amovibles Partie12:FormeS Reference number IS0 5610-12:2014(E) LSO IS02014 HS under ted without license from IHS Not for Resale IS0 5610-12:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 5610-12:2014(E) Contents Page Foreword ..iv 1 Scope 2 Normative references 3 Dimensions. 3.1 General ..1 3.2 Tool holder style S for rhombic indexable insert shape C 3.3 Tool holder style S for square indexable insert shape S 4 3.4 Tool holder style S for round indexable insert shape R .7 4 Designation .10 5 Material. ..11 6 Design.. ..11 6.1 Type of mounting ..11 6.2 Corner radius, rs. . 11 6.3 Thickness, s, of indexable insert 11 7 Extent of delivery ..12 8 Marking ..12 Bibliography ..13 iii ded by IHS under lic cense with ISt ed without license from IHS Not for Resale