ISO INTERNATIONAL STANDARD 5356-1 Fourthedition 2015-03-15 Anaesthetic and respiratory equipment Conical connectors Part 1: Cones and sockets Materiel d'anesthésie et de réanimation respiratoire - Raccords coniques- Partie 1: Raccords males etfemelles Reference number ISO 5356-1:2015(E) SO International Organization for Standardization @ IS0 2015 Zhejiang Institute of Standardization 5956617 vided by IHS under Not for Resale, 2015/6/2 07:15:35 itted without license from IHS IS0 5356-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/6/2 07:15:35 networking permitted without license from IHS IS0 5356-1:2015(E) Contents Page Foreword .iv Introduction ..V 1 Scope. .1 2 Normative references .1 3 Dimensional requirements .1 3.1 General requirements 1 3.2 Additional requirements ..3 4 22 mm latching sockets 4 Annex A (normative) Plug and ring test gauges for cones and sockets made of materials other than metal .5 Annex B (normative) Test for security of engagement of 22 mm latching sockets to cones .7 Annex C (normative) Test forleakage from 22 mm latching sockets .8 Annex D (normative) Drop procedure for 22 mm latching sockets .9 Annex E (informative) Plug and ring test gauges for cones and sockets made of metal .10 Annex F (informative) Suggested apparatus and methods for testing the security of engagement of 22 mm latching sockets. .12 Bibliography .17 iii Instituteof Standardization 5956617 ut license from IHS