ISO/IEC TECHNICAL REPORT TR 18047-7 Second edition 2010-07-01 Information technology Radio frequency identification device conformance test methods Part 7: Test methodsfor active airinterface communications at 433 MHz Technologiesdel'information-Methodesd'essaideconformitedu dispositifd'identificationderadiofrequence- Partie 7: Methodes d'essai pour des communications d'interface d'air active a 433 MHz Reference number ISO/IEC TR 18047-7:2010(E) IEC ISO @ISO/IEC2010 ISO/IECTR18047-7:2010(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ISO/IEC2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISso's member body in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva20 Tel. + 4122749 0111 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.org Published inSwitzerland @ ISO/IEC 2010-All rights reserved without license from IHS Not for Resale ISO/IECTR18047-7:2010(E) Contents Page Foreword .iv Introduction 1 Scope 2 Normativereferences. 3 Terms, definitions, symbols and abbreviated terms 3.1 Termsanddefinitions.. 3.2 Symbolsandabbreviatedterms 4 Physical ConformanceTests.. 4.1 4.2 Default itemsapplicabletothetestmethods 4.3 Test set-up and measurement equipment... 4.4 Physical LayerParameterValues and Limits 4.5 Functional Test -Interrogator..... 4.6 Functional Test-Tag 15 5 Command Protocol Conformance Tests.. 21 5.1 General. 5.2 Default items applicable to the test methods 21 5.3 Test Setup. 21 5.4 Interrogator Commands - Mandatory 21 5.5 Tag Commands - Mandatory.... 25 5.6 Tag Commands - Optional..... ili se from IHS Not for Re